CompactPCI * Accessories
CY-90-TPMC851-10R	PMC-Karte TPMC851-10R Multifumction I/O 16bit AD, 16 bit DA, TTL I/O, Counter
CY-90-TPMC851-SW-65	Windows Device Driver. Multifunction I/O (16 bit ADC/DAC, TTL I/O, Counter). Version 3.1.x.
CompactPCI * Adapter
CA2-1-FUNK	3U, adapter PCI-to-CPCI (carrier/bridge), 1 PCI slot suitable for PCI Card 57.00mm x 160.00mm, front panel width 8HP
CA2-3-FUNK	3U, adapter PCI-to-CPCI (carrier/bridge), 3 PCI slots suitable for PCI Short Cards, front panel width 28HP (completely covering the PCI Cards)
CA2-4-FUNK	6U, adapter PCI-to-CPCI (carrier/bridge), 1 PCI slot suitable for PCI Card 107.00mm x 160.00mm ( > 160,00mm depends on system properties) front panel width 8HP
CompactPCI * CAN Fieldbus
CX2-1-GROUP	3U, dual CAN 2.0A/B hostadapter, 1 x CAN controller SJA1000, optically isolated, incl. driver for Windows/Linux
CX2-2-GROUP	3U/4HP, dual CAN 2.0A/B hostadapter, 2 x CAN controller SJA1000, optically isolated, incl. driver for Windows/Linux
CompactPCI * CPU Mezzanine
C48-1-M2	Add-on module (low profile), 2 x M.2 SATA SSD sockets, for M.2 2230/2242/2260/2280 SSD modules Suitable for M.2 S1-S5 / D1-D4
CCO-4-CONCERT	3U/4HP Mezzanine expansion board for CCM/PC1/2/3/SC1 front panel I/O includes USB, audio (line-In -Line Out), 2x COM Port, on-board SATA port for 2.5" device
CompactPCI * ExpressCard
CP5-11-GLAM	3U, new technologies carrier board: two PCI Express MiniCard sockets incl. SIM/UIM card holders, 6 x SMA antenna connectors for MIMO WiFi/GSM/WiMax
CompactPCI * Network Switching
CL2-05X-BRASS	Gigabit Ethernet switch, 5 x M12 (8-lead X-coded) F/P receptacles, +5V via 4 pin onboard power connector (P2), temperature range -25°C to +85°C conform EN 50155/T3
CL2-06X-BRASS	Gigabit Ethernet switch, 5 x M12 (8-lead X-coded) F/P receptacles, +5V only via J1 CPCI backplane connector, temperature range -25°C to +85°C
CompactPCI * Networking
CN7-05-REVERB	5-Port Gigabit Ethernet controller, 5 x RJ45 front panel connectors
CN8-0500-REVERB	5-Port Gigabit Ethernet controller, 5 x RJ45 front panel connectors
CompactPCI * PMC/XMC Carrier
CK2-1-SESSION	XMC module carrier board, 32-bit 33/66MHz PCI to PCI Express bridge, XMC connector J15, PCI Express 2.5Gbps single lane
CompactPCI * System Rack
CR1-3-RACK	1U 19-inch rack, 3+1 slots for 3U CompactPCI cards, rear I/O, PSU 250W 90-264V 50/60Hz (+5/+3.3/+12/-12V), 1 x system slot 3U 4HP/8HP, 2 x peripheral slots 3U/4HP seven 4HP blind panels and power cable included
CR4-15-RACK	19" System rack 4U/84HP PlusIO cPCI System 3 cPCI, 1x PlusIO, 4x cPCI-S.0, 250W PSU AC 1 U hot-swap fan unit.
CR4-2-RACK	19" System rack 4U, 8-slot CompactPCI backplane 3U P1-P2, industrial ATX power supply, 1U fan unit, depth 280mm, suitable for 3U CompactPCI boards
CR4-4-RACK	Similar to CR4-2-RACK, but Rear I/O backplane
CR5-65-RACK	19" 4U/84HP CompactPCI PXI Chassis desktop system 14 slot backplane with PCI-2-PCI bridge and P47 250W PSU 230VAC, pwr-in rear Power switch front, dust filter, 2x 8HP panel
CR9-5-ADAPT	front panel expansion adapter for 3U board mounting in 6U racks, suitable for all EKF 3U (4HP) boards,
CR9-6-ADAPT	same as CR9-5, but double width (8HP)
CRB-1-BLUELINE	BLUELINE 3U/30HP small system rack, w h d ~ 172mm x 132mm x 208mm, incl. tip up feets CPCI PSU 70W 115/230VAC(3.3V,5V) CPCI backplane 4 x P1, suitable for 3U CompactPCI boards
CRB-4-BLUELINE	BLUELINE 3U/30HP small system rack incl. fan unit, w h d ~ 172mm x 166mm x 208mm, CPCI PSU 70W 115/230VAC (3.3V,5V), CPCI 4 x P1, suitable for 3U CompactPCI boards
CRB-5-BLUELINE	Similar to CRB-4-BLUELINE, 24VDC power line input
CRB-8-BLUELINE	Bottom mount brackets
CompactPCI * UART
CUD-01-TWIST	Serial interface 4 x isolated RS-485 half/full-duplex, 4 x RJ45 front panel connectors, pinout suitable for CU4 replacement. Please refer to ekf.com -> CUD-TWIST PIE: Alternate 2
CUD-02-TWIST	Serial interface 4 x isolated RS-485 half/full-duplex, 4 x RJ45 front panel connectors, pinout suitable for CU4 replacement, additional 4 Ports via J2, CU9 and (CU7 or CU8).
CUE-01-BALLAD	Serial interface 4 x isolated RS-232, 4 x RJ45 front panel connectors, pinout suitable for CU4 replacement.
CUE-02-BALLAD	Serial interface 4 x isolated RS-232, 4 x RJ45 front panel connectors, pinout suitable for CU4 replacement, additional 4 Ports via J2, CU9 and (CU7 or CU8).
CompactPCI * USB 3.0
CB3-1-TONE	Quad port USB 3.0 controller
CB3-97-TONE	Quad port USB 3.0 controller incl. conformal coating
CB3-P1	Quad port USB 3.0 controller
CompactPCI * Video/Graphics
CV2-1-LOUNGE	Dual display graphics processor, up to 1920x1440, dual-view independent outputs, 32 bit per pixel 2 x DVI-I (18 bit per pixel) video output connectors 5V supply voltage only
CV2-2-LOUNGE	Dual display graphics processor, up to 1920x1440, dual-view independent outputs, 32 bit per pixel 2 x VGA video output connectors 5V supply voltage only
CV2-3-LOUNGE	Dual display graphics processor, up to 1920x1440, dual-view independent outputs, 32 bit per pixel 1 x DVI-I connector, 1 x VGA connector 5V supply voltage only
CVX-0100-DVI	Dual DisplayPort to DVI adapter, 2 x mDP inputs, 2x DVI outputs, selectable DVI-D or DVI-A (VGA)
CVX-0200-DVI	Dual DisplayPort to DVI adapter, 2 x mDP inputs, 2x DVI outputs, selectable DVI-D or DVI-A (VGA) 1x VGA output via J2